Perry Johnson Registrars, Inc | UKASANABITAR
All Categories > Pre-Engineered Journal, Guide, Thrust & Dryer Bearings > Dryer Bearings > 700 Series Dryer Bearings > Customize a Type 700 Dryer Bearing Assembly  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Customize a Type 700 Dryer Bearing Assembly



The unique Type 700 Series Bearing Assembly was designed to provide a robust alternative to full diameter bearings where an open top half bearing is appropriate. The "block" type half bearing cartridge of the 700 Series Assemblies provides for quick replacement without hand tools or concern for losing loose hairpin cotters or bearing retainers. All of the components of the 700 Series remain attached to the frame during bearing replacement.

The extra thick cross section of the 700 Series bearing provides longer wear life. Nearly ½" of bearing wear can take place without any harm to the shaft journal. The Type 700-1 Bearing Assembly features the same self-aligning advantages as our other full diameter bearing assemblies.

Special Features:
  • Supplied in all Metcar® bearing grades
  • Self-lubricating and maintenance free
  • Replacement bearings can be installed quickly with minimum shaft lifting
  • Thick half block bearings allow for more wear and more time between bearing changes
  • Faces can be used for light thrust loading
  • Self aligning assembly (compensation for shaft deflection and misalignment)
  • Cost effective, compact design
How To Customize and Order

When ordering a Type 700 Series Bearing Assembly, the following information is needed to determine the correct assembly for your application:
  1. Choose a hanger frame suitable for your application. All 700 Series frames are symetrical, therefore shaft rotation does not need to be specified when ordering.
  2. Choose a bearing cartridge - The standard length of the 700 Series Half Bearing is 1 ½ Long and will be supplied this way unless otherwise specified. Other lengths may be specified for the 700-1 Assembly only.
  3. Choose a grade - if you do not know the applicable grade, a grade can be determined based on the maximum temperature and other operating conditions of the application.
  4. Specify the bore size or shaft size required for the application.
  5. A 700- EZ Clip Spring is necessary for each assembly to hold the bearing cartridge in place on the 700-1 Assembly only. The EZ clip spring allows for one hand access to the bearing cartridge.

Click Here to Customize a Type 700 Dryer Bearing Assembly



Site created by Thomas Web Solutions and powered by Navigator Platform